USES - These centrifugal electric water pumps with one IMPELLER of BRASS are suitable to handle clean or slightly cloudy, non-corrosive water not exceeding 50° C. temperature. They are ideal to provide water supply to domestic dwellings, farms, industrial units etc. They are also most suitable as water booster sets, boiler-feed pumps, tank filling, car washing, fountain feeding, agricultural and horticultural applications, etc.

PUMP SIDE - Cast-iron pump body and bracket of solid design, BRASS IMPELLER, stainless steel shaft, high quality mechanical seal, inlet and outlet threaded according to UNI 338-66 gas. This series of pumps can be disassembled and reassembled without removing the piping to the B.P.O. (Back Pull Out).

ELECTRIC MOTOR - Heavy duty, continuous service, induction motor builit to IEC 2-3 issue 1-1974 ref. 355 regulations. Built-in overload motor protector for single phase version. Protection according to IP44 Standards. Size according to UNEL-MEC specifications

PRODUCTION STANDARDS - The pump side is in cast-iron and is built to ISO 2548 regulations. The motor to IEC (International Electrotechnical Commission) specifications.

QUALITY CONTROL - All our pumps are individually factory tested according to UNI 6871-71P cat Ill Standards.

VOLTAGE -

Slngle phase: 180V - 220V

Three phase: 380V - 440V

Maximum allowable deviation from the rated voltage ±5%

(Other voltages available on demand).

FREQUENCY - 50 Hz.

WARRANTY PERIOD - 24 months.